DANLERS CEPH RE 설치 참고 사항 - 페이지 2
{카테고리_이름} DANLERS CEPH RE에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. DANLERS CEPH RE 2 페이지. Ceiling socket mounted photocell switches
페이지 인쇄Installation procedure
1. Please read these notes carefully before commencing work.
In case of doubt please consult a qualified electrician.
2. Make sure the power is isolated from the circuit.
The Photocell should be plugged into a Klik-AX socket connected
as shown in diagram A:
L
Live in
N
Neutral in
A
Switched Line out
3. DANLERS sell the Klik-AX sockets under the following codes:
CESO:
Circular Klik-AX socket for Besa box
CESO SQ: Square Klik-AX socket for single gang back box
4. Switch on the supply and check the operation.
Lux set-up
The LUX is best set up when it is dark outside and the lights are on.
To do this turn the LUX control fully clockwise to '-' then slowly anti-
clockwise (towards '+') until the red LED turns on.
A: Wiring diagram
L N
Manual wall switch:
Optional for CEPH NO,
for override off.
Compulsory for CEPH RE,
to reset the photocell.
Back box or
BESA box
CESO or
CESO SQ
CEPH NO or
L
N SL
CEPH RE
(A)
B: Adjusting Lux
100
1000
max
min
LUX
Lamp
load