Consort CRXSL-05 설치 및 사용자 설명서

{카테고리_이름} Consort CRXSL-05에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Consort CRXSL-05 6 페이지. Single zone wireless controller

Please read this guide carefully and retain for future use and maintenance.

CRXSL

1. Introduction

The CRXSL Wireless Controller can control any 'RX' or 'SL' heater, including multiple products at the same time.

The CRXSL must be paired to each heater, otherwise the heaters will not work (see section 3).

For options for powering the CRXSL see section 18.

2. Getting to know your CRXSL wireless controller

buttons

The control buttons perform the following basic functions:

Decrease / Increase value: by default this adjusts the set temperature. When the set temperature is adjusted

above the measured room temperature, the heater active symbol is shown and any paired heaters are

switched on.

Mode: cycle through operating modes Boost, Manual, Setback and Program (see sections 6-9).

By default Setback mode is disabled (see section 8).

Fan: cycle through fan speed settings (for fan heaters only). No fan symbol shown means low speed, one fan

symbol is medium speed, two fan symbols is high speed.

Pressing fan when heating is inactive will activate fan only mode (for compatible fan heaters).

In fan only mode, FAN is shown on the display. Exit fan only mode by cycling through the fan speed

settings until FAN is not shown.

Programme: used for advancing programme, setting the time and accessing programming menu.

Important display icons:

Heat icon: this is displayed when the heating is active. RX heaters will operate at reduced heat output when

close to the set temperature, and half the icon is shown:

Lock symbol: this is displayed when the CRXSL controls are locked. Hold

unlock or lock the controls.

ALARM! Flashes to indicate an error in the programme setup, e.g. the time for programme 2 is set earlier than the

time for programme 1.

I3984133 Iss 05

Single Zone

Wireless Controller

Installation and User Guide

and

together for 5 seconds to