DAPAudio IEM-100 Beltpack 제품 설명서 - 페이지 9

{카테고리_이름} DAPAudio IEM-100 Beltpack에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio IEM-100 Beltpack 17 페이지. Wireless in ear monitor set
DAPAudio IEM-100 Beltpack에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지)

 Equalizer Setting:
Press the SET button until EQ is flashing (Figure 12). Use the Up or Down button to adjust the Audio
Balance.
Note: If no button is pressed for 3 seconds, the system will automaticly exit the setting state and
save the current setting.
Receiver Functions
1. Limiter function;
If the limiter is switched on, the volume will corrected automatically if the value rises above the set
threshold. This in order to avoid distortion and protect your ears.
2. Equalizer setting:
3. Squelch setting:
If the RF signal is less then the squelch setting. The signal indicator will dim and the audio output
will be muted.
Mix Mode/ Stereo Control
The receiver receives two signals (1/L and 2/R) from the transmitter and then processes these signals in
either mix or stero mode.
Stereo Mode
In stereo mode the signals remain separate so that 1/L is heard through the left headphone and 2/R is
heard through the right headphone. The balance knob on the receiver can be used to adjust the
balance between the left and right headphones. See Figure 14.
Treble boost 6dB
Bass boost 6dB
Bass + treble boost 6dB
Flat
7
Fig. 8
Fig. 9
Fig. 10