Contemporary Research ICC1-IRX 제품 설명서 - 페이지 5

{카테고리_이름} Contemporary Research ICC1-IRX에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Contemporary Research ICC1-IRX 19 페이지. Ir tv controller, 1-way rf coax control

페이지 인쇄

Installation

AC Power Test

1. Insert DC power supply plug into 12 VDC jack.

2. Plug power adaptor into AC wall outlet.

3. The Net LED should turn on and stay lit.

RF Coax and iCC-Net Operation

1. Connect the TV to CATV and observe quality of RF broadcasting. A low-quality CATV system can also affect

performance of the iCC-Net commands. If needed, fix CATV problems before installing the system.

2. Connect the CATV RF Coax cable into the RF In input on the ICC1-IRX.

3. If the iCC-Net signal is operating, the Net LED will blink once per second.

4. Connect the RF loop cable from the RF Out jack to the TV's RF connector (you lose less than 1.5 dBmV going

through the ICC1-IRX'S internal RF tap).

TV Power Sensing

1. To sense power on flat-panel TVs (those cheapies that don't have a discrete power on and off command), use the

Xantech CSM1 power current sensor.

2. Insert CSM1 into the CSM1 input, sensor LED will light when the CSM senses power on status

3. You can also use a USB Sensor cable in the CSM port – the USB connector fits into the USB connection on the TV

Tip:

IR control test: When you install the IR cable, flip S2 Switch 6 ON. Then flip S2 Switch 1 ON to send an IR power

command. Turn Switch 1 OFF, then turn Switch 2 on to send and Off IR command. After testing, turn S2 Switch 6

OFF.

Contemporary Research

ICC1-IRX