Contemporary Research ICC1-IRX 제품 설명서 - 페이지 6
{카테고리_이름} Contemporary Research ICC1-IRX에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Contemporary Research ICC1-IRX 19 페이지. Ir tv controller, 1-way rf coax control
페이지 인쇄
Installation
Setting IR Control Codes (IR Type Mode)
Turn enclosure so the DIP switches are on the bottom
In most cases, it's easier to use our Display Express software, the IC Send app, or your control system to change the IR code set you
want to use. See the section on page 11 on using our software to set the IR code set that way.
You can change the IR code type by turning on S2 Switch 6 on the right, and setting a type number on S1 switches 1-6. There are
also options you can add in as well to set special features, such as using the CSM1 Power Sensor.
1.
Apply DC power to the ICC1-IRX.
2.
If the unit's device number has already been set, note the current settings for S1 switches 1-8 and S2 switches 1-4 – you
will reset those switches when you're done.
3.
Set S2 Switch 6 to ON.
4.
Look at the IR Control Code chart on next page and select the desired value.
5.
The S1 switches enter a binary value, so S1 Switch 6 represents 32.
6.
Set S1 Switches 1 – 6 to match the value. For example to select the Sharp type 46,
turn on S1 switches 2, 3, 4, and 6, which adds 2+4+8+32 = 46
7.
When you turn switch 6 off, your IRX will now output the latest Sharp codes.
8.
You can add options to your basic code as well. For example, if you're not using a CSM1 for a Dynex TV, you need to turn
that feature off. Adding S1 Switch 7 adds 64 to the value, and the IRX will ignore the input.
9.
For that Dynex TV, S1 Switch 8 would be off, which means toggling power. Very few international TVs use the 1 Key to
turn on the set, but the IRX will use that if you add the switch on to your code set.
10. You can usually ignore S2 Switch 5, which handles how the Enter code is after the channel #.
11. S2 Switch 7 only applies for the CC-HSD sensor for tube TVs, it does not affect the CSM1 input.
12. S2 Switch 8 can lower the IR emitter power, if the normal level is too high for that TV. This works independently from
Type and Device settings.
13. If unit's device number had been set before, return S1 switches 1-8 and S2 switches 1-4 to previous positions.
S1
Off Value
1
0
2
0
3
0
4
0
5
0
6
0
7
0 - Use Power Sensor
8
0 - Toggle power
S2
1
2
3
4
5
Channel Entry Off
6
Device Number Mode
7
CC-HSD Low
8
Low IR power
Contemporary Research
On Value
1
2
4
8
16
32
64 - Ignore Power Sensor
128 - Key 1 = Power On
Modify Channel Entry
IR Type Mode
CC-HSD Hi
High IR power (Default)
6
ICC1-IRX