Addvent AVAC9000W 설치 지침 및 사용자 설명서 - 페이지 6

{카테고리_이름} Addvent AVAC9000W에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Addvent AVAC9000W 9 페이지.

AVAC9000W[15]instructions

Installation

Connect exhaust hose assembly to the back of the unit. Extend

supplied hose to desired length and locate the exhaust nozzle

through the window for ventilation.

Insert both ends of the exhaust hose into the two exhaust

nozzle connectors by twisting anti-clockwise until they stop.

Fix one of the connectors to the rear outlet of the unit.

This is achieved by sliding the nozzle connector downwards

over the exhaust outlet of the unit ensuring that the lugs on

the nozzle connector are engaged with the grooves on the

connector of unit.

Fix the other exhaust nozzle connector to the exhaust

nozzle.

Extend the exhaust hose and close the window as much as

possible trapping the exhaust nozzle.

If required, your appliance can also be installed

semi-permanently.

Drill a 125mm hole in an outside wall* or through a

window pane.

The unit should not be within 300mm of any wall.

Fit the flange accessory fixture provided in the hole.

Fit the exhaust hose in the housing at the back of the

appliance.

Insert the other end of the exhaust hose to the flange

previously fit on the wall as shown.

When the hose is not in use, place the cap for connector to

cover the hole.

NOTE : When installing the air conditioner semi permanently,

you should leave a door slightly open (as little as 1cm) to

guarantee sufficient ventilation.

* Installing through an outside wall: you are recommended to

insulate the section of wall using suitable insulation material.

9/4/15

09:43

Page 6

Exhaust nozzle

Exhaust

hose

Exhaust nozzle

connectors (2)