DURRIDGE RAD7 블루투스 연결 매뉴얼 - 페이지 2

{카테고리_이름} DURRIDGE RAD7에 대한 블루투스 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DURRIDGE RAD7 4 페이지. Passive, slow response radon in water accessory
DURRIDGE RAD7에 대해서도 마찬가지입니다: 연결 매뉴얼 (4 페이지), 사용자 설명서 (7 페이지), 사용자 설명서 (15 페이지)

페이지 인쇄

Figure 1: The Keyspan Serial Assistant: This utility reveals the name of the COM port that has been created by

the USB to Serial Adaptor. In this case, it is "COM3".

4. Connect the SD1000's power cord and slide its power switch to the ON position.

5. Install and launch the ParaniWin application on the computer. Upon launching the program, a

dialog box titled UART Setting will appear, prompting you to specify a number of parameters, as

shown in Figure 2, below. Conﬁgure the device as follows: 

• Set the Serial Port to the appropriate setting, as determined in Step 3, above.

• Set the Baud Rate to 9600.

• Set the Parity None.

• Set the StopBit to 1.

Figure 2: The ParaniWin UART Setting Dialog: This dialog appears when launching ParaniWin. It is used to

locate the SD1000 Adaptor so that it can be conﬁgured.  