DURRIDGE RAD7 Manual de ligação Bluetooth - Página 2
Procurar online ou descarregar pdf Manual de ligação Bluetooth para Equipamento de laboratório DURRIDGE RAD7. DURRIDGE RAD7 4 páginas. Passive, slow response radon in water accessory
Também para DURRIDGE RAD7: Manual de conetividade (4 páginas), Manual do utilizador (7 páginas), Manual do utilizador (15 páginas)
Imprimir página
Figure 1: The Keyspan Serial Assistant: This utility reveals the name of the COM port that has been created by
the USB to Serial Adaptor. In this case, it is "COM3".
4. Connect the SD1000's power cord and slide its power switch to the ON position.
5. Install and launch the ParaniWin application on the computer. Upon launching the program, a
dialog box titled UART Setting will appear, prompting you to specify a number of parameters, as
shown in Figure 2, below. Configure the device as follows:
• Set the Serial Port to the appropriate setting, as determined in Step 3, above.
• Set the Baud Rate to 9600.
• Set the Parity None.
• Set the StopBit to 1.
Figure 2: The ParaniWin UART Setting Dialog: This dialog appears when launching ParaniWin. It is used to
locate the SD1000 Adaptor so that it can be configured.
2