2easy CDV17D 설치 매뉴얼 - 페이지 8
{카테고리_이름} 2easy CDV17D에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2easy CDV17D 12 페이지. 2-wire intercom system
페이지 인쇄DIP Switch Setting
The DIP switch is designed to set the code the for door station and the monitor, there
are two states for each DIP switch, please refer to the following:
ON(1)
O N
=
Door station DIP setting
Total 3 bits can be configured, bit-1 and bit-2 are used to assign ID code for door
station, bit-3 is used to match the video impedance.The switches can be modified either
before or after installation.
Bit state
ON
1 2
3
ON
1 2
3
ON
1 2
3
ON
1 2
3
Note: for video impedance EOL: set the bit-3 on.
Indoor monitor DIP setting
There are 6 bits in total. The DIP switches are used to configure the user address for Monitors.
Bit-6 is an video impedance EOL switch, set to ON to match the impedance.
Bit-1~Bit-5 are used to set user address, the user code should set be set to
0~15. Please refer to the following settings:
OFF(0)
O N
=
ID = 0(00), set to the first door station
ID = 1(10), set to the second door station
ID = 2(01), set to the third door station
ID = 3(11), set to the fourth door station
Description
-7-