Elsema Gigalink GLR2708 설정 및 프로그래밍 지침 - 페이지 5
{카테고리_이름} Elsema Gigalink GLR2708에 대한 설정 및 프로그래밍 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Elsema Gigalink GLR2708 8 페이지. 8-channel 27mhz receiver with open collector outputs
Elsema Gigalink GLR2708에 대해서도 마찬가지입니다: 매뉴얼 (7 페이지)
페이지 인쇄
SINGLE CHANNEL PROGRAMMING
This is used for programming one channel at a time to the transmitter. Single channel programming can
be achieved by following the steps below:
Step 1:
Connect power to the GIGALINK
dipswitch are off.
Step 2:
Momentarily short the two CC pins on the receiver board. This sets all the channels to
a random code. If there are transmitters previously programmed, they will have to be
re-programmed when CC pins are shorted.
Step 3:
Select the receiver channel, to be programmed, by setting the 4-way dipswitch. See
dipswitch table below.
Off
On
Off
On
Off
On
Off
On
Step 4:
Connect the transmitter to the receiver by inserting the GIGALINK
transmitters and receivers 2.5-mm Coding socket. (This will activate the programming
mode and is indicated by the red light (LED) on the transmitter that must remain "on").
Step 5:
Activate one of the selected channels on the transmitter for approximately one
second, LED should blink twice to confirm code programming and then switch "off".
Step 6:
Disconnect GIGALINK
Repeat steps 3 to 6 to program another transmitter channel.
If you are programming another transmitter, do not short out the CC pins. Shorting out the CC pins
will delete all previously programmed transmitters.
Enter the World of Wireless
™
Dipswitch Setting
1
2
Off
Off
On
On
Off
Off
On
On
cable.
™
receiver. Make sure all switches on the mode
Receiver Channel
3
Off
Off
Off
Off
On
On
On
On
1
2
3
4
5
6
7
8
cable into the
™
5