Elsner Corlo Touch KNX 기술 사양 및 설치 지침 - 페이지 9

{카테고리_이름} Elsner Corlo Touch KNX에 대한 기술 사양 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Elsner Corlo Touch KNX 12 페이지. Display and touch switch
Elsner Corlo Touch KNX에 대해서도 마찬가지입니다: 기술 사양 및 설치 지침 (2 페이지)

페이지 인쇄
Elsner Corlo Touch KNX 기술 사양 및 설치 지침
 Settings > System > Service > KNX
4.

Maintenance and care

Fingerprints on the glass area and frame are best removed with a cloth moistened with
water or a microfiber cloth. Do not use an abrasive cleaning agent or aggressive
cleansing agents.
For cleaning of the screen, the „cleaning mode" can be used, that is activeted via the
display.
 Settings > Cleaning Mode
During a period set in the ETS, the touch function is disabled then and the screen can
be cleaned.
5.
Load individual images
5.1. Images for screensaver
Images that are shown as the screensaver must be stored on a micro SD card. In order
that the system can recognize the SD card, carry out a reset in the menu after inserting
it
Settings> System > Reset
Display Corlo Touch KNX • Status: 06.08.13 • Technical changes and errors reserved.
9
KNX programmming LED ON:
Programming mode active.
KNX programming LED OFF:
Programming mode off.
The current address is displayed (Address
15.15.250 when delivered).
Maintenance and care