CB2 HYDE 조립 지침 - 페이지 5
{카테고리_이름} CB2 HYDE에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CB2 HYDE 5 페이지. Square open wall ccabinet
CB2 HYDE에 대해서도 마찬가지입니다: 조립 지침 (4 페이지), 조립 지침 (4 페이지)
페이지 인쇄hyde
SQUARE WALL CABINET
wall attachment assembly
wall template
wall attachment
bracket pre-installed
on wall console
WALL
NOTE: Make sure arm hinge is orientated on
top and door opens to the left during wall
attachment assembly
wall bracket
Made in Vietnam - r04
VERTICAL DOOR
ORIENTATION
wall attachment
bracket
BACK OF
ASSEMBLY
The wall mounting hardware included with this wall console is intended for drywall
installation only. Be sure to use hardware appropriate for your wall type. Whenever
possible, fasten screws directly into a wall stud. If you are unsure about your wall type or
what mounting method you should use, consult a qualified professional or your local
hardware store.
1. Determine the wall console orientation (vertical or horizontal door) and wall
location. Using a level for the provided
wall bracket as shown.
2. If attaching directly into wall studs, skip to Step 4.
3. For drywall installation, drill a hole slightly smaller in diameter than the anchor. Insert 1
plastic anchor at each marked hole location and gently tap with a hammer until the head
of each anchor is flush to the wall surface.
4. Insert 1 large screw through each hole in the wall bracket and into the corresponding
anchors or studs in the wall. Fully tighten each screw with a phillips head screwdriver
but do not over tighten.
5. With the assistance of another adult, fit the bracket on the back of the unit onto the wall
bracket. Make sure the unit is firmly seated in the wall bracket.
Wall attachment is now complete.
Customer Service 800.606.6252 | Latest instructions available on www.cb2.com
wall template
wall attachment
bracket
BACK OF
ASSEMBLY
wall template, level and mark hole positions for
Discard wall template.
HORIZONTAL DOOR
ORIENTATION
wall attachment
bracket pre-installed
on wall console
WALL
NOTE: Make sure arm hinge is
orientated on the right and door
opens upward during wall
attachment assembly
Page 5 of 5