Datamax I-Class Mark II 설치 및 사용 설명서 - 페이지 4

{카테고리_이름} Datamax I-Class Mark II에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datamax I-Class Mark II 12 페이지. General purpose input output (gpio) option
Datamax I-Class Mark II에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄

1. Installing the Option
2. Setup and Operation

Installing the Option

If the GPIO Card is already installed in the printer, skip this section and proceed to

"Configuring the Hardware". Otherwise, install the GPIO Card as described below:

A) Turn off and disconnect the power cord from the printer. Remove the three Screws

from the left side cover of the printer.

B) Open the printer's cover, loosen (do not remove) the two Screws on the inside of the

printer and lift the Cover Assembly up and off the printer.

Screws

Cover

Assembly

Screws