Datamax M-Class Mark II 매뉴얼 - 페이지 10

{카테고리_이름} Datamax M-Class Mark II에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datamax M-Class Mark II 10 페이지. Rfid option
Datamax M-Class Mark II에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지), 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (8 페이지)

페이지 인쇄

 Remove Upper Roller Shaft and associated

Rollers.

 Clean all surfaces of the Rollers and the Upper

Roller Shaft. Isopropyl Alcohol can be used,

for heavy or stubborn deposits WD-40 or an

adhesive remover can be used. Be sure all the

ridges on the rollers are free of debris.

 Re-assemble the Upper Roller Shaft, Rollers,

and C-Clip into the Peel Mechanism Assembly.

Lower Rollers:

 Remove the Peel Mechanism from the printer.

Press in on the Latch and allow the Front Cover

to swing open.

 Push in on the Tab as shown, repeat for the

other side and then remove the entire Lower

Roller Assembly.

 Remove Lower Roller Shaft and associated

Rollers. Note the order of the Rollers as they

are removed, they must be re-installed in the

same order.

 Clean all surfaces of the Rollers and the Lower

Roller Shaft. Isopropyl Alcohol can be used,

for heavy or stubborn deposits WD-40 or an

adhesive remover can be used. Be sure all the

ridges on the rollers are free of debris.

 Re-assemble the Lower Roller Shaft and

Rollers. Reinstall the assembly into the Peel

Mechanism Assembly

Upper Roller

Shaft

Lower Roller

Assembly

Lower Roller

Shaft

Rollers

Push in on Tab