2easy DT594 사용자 설명서 - 페이지 9
{카테고리_이름} 2easy DT594에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 2easy DT594 12 페이지. 2-wire door station
2easy DT594에 대해서도 마찬가지입니다: 매뉴얼 (13 페이지)
페이지 인쇄
DIP Switches Setting
The DIP switch is designed to set the code
for door station and monitor, there are two
states for each DIP switch, please refer to
the sketch map.
Door station DIP setting
Total 2 bits can be configured, bit-1 and bit-2 are used to assign ID code for door sta-
tion.The switches can be modified either before or after installation.
Bit state
ON
1 2
ON
1 2
ON
1 2
ON
1 2
Indoor monitor DIP setting
There are 6 bits in total. The DIP switches are used to configure the user code
for Monitors.
Bit-6 is an video impedance match switch, which have to be set to ON if match
the impedance, otherwise set to OFF.
Bit state
Setting
ON
Not match
1 2 3 4 5
6
Bit-1~Bit-5 are used to set user code. If the door station with one call button,
the user code should be set to 0~15. If the door station with two call buttons,
the user code should be set to 0~31.
Please refer to the following settings:
Default setting, ID = 0(00), set to the first Door Station.
ID = 1(10), set to the second Door Station.
ID = 2(01), set to the third Door Station.
ID = 3(11), set to the fourth Door Station.
Bit state
ON
Match the video impedance
1 2 3 4 5
6
ON(1)
O N
=
Descriptions
Setting
OFF(0)
O N
=
-9-