2easy DT594 Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Домофонна система 2easy DT594. 2easy DT594 12 сторінок. 2-wire door station
Також для 2easy DT594: Посібник (13 сторінок)
Друкувати сторінку
DIP Switches Setting
The DIP switch is designed to set the code
for door station and monitor, there are two
states for each DIP switch, please refer to
the sketch map.
Door station DIP setting
Total 2 bits can be configured, bit-1 and bit-2 are used to assign ID code for door sta-
tion.The switches can be modified either before or after installation.
Bit state
ON
1 2
ON
1 2
ON
1 2
ON
1 2
Indoor monitor DIP setting
There are 6 bits in total. The DIP switches are used to configure the user code
for Monitors.
Bit-6 is an video impedance match switch, which have to be set to ON if match
the impedance, otherwise set to OFF.
Bit state
Setting
ON
Not match
1 2 3 4 5
6
Bit-1~Bit-5 are used to set user code. If the door station with one call button,
the user code should be set to 0~15. If the door station with two call buttons,
the user code should be set to 0~31.
Please refer to the following settings:
Default setting, ID = 0(00), set to the first Door Station.
ID = 1(10), set to the second Door Station.
ID = 2(01), set to the third Door Station.
ID = 3(11), set to the fourth Door Station.
Bit state
ON
Match the video impedance
1 2 3 4 5
6
ON(1)
O N
=
Descriptions
Setting
OFF(0)
O N
=
-9-