2easy DT594 Podręcznik użytkownika - Strona 9
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla System interkomu 2easy DT594. 2easy DT594 12 stron. 2-wire door station
Również dla 2easy DT594: Podręcznik (13 strony)
Drukuj stronę
DIP Switches Setting
The DIP switch is designed to set the code
for door station and monitor, there are two
states for each DIP switch, please refer to
the sketch map.
Door station DIP setting
Total 2 bits can be configured, bit-1 and bit-2 are used to assign ID code for door sta-
tion.The switches can be modified either before or after installation.
Bit state
ON
1 2
ON
1 2
ON
1 2
ON
1 2
Indoor monitor DIP setting
There are 6 bits in total. The DIP switches are used to configure the user code
for Monitors.
Bit-6 is an video impedance match switch, which have to be set to ON if match
the impedance, otherwise set to OFF.
Bit state
Setting
ON
Not match
1 2 3 4 5
6
Bit-1~Bit-5 are used to set user code. If the door station with one call button,
the user code should be set to 0~15. If the door station with two call buttons,
the user code should be set to 0~31.
Please refer to the following settings:
Default setting, ID = 0(00), set to the first Door Station.
ID = 1(10), set to the second Door Station.
ID = 2(01), set to the third Door Station.
ID = 3(11), set to the fourth Door Station.
Bit state
ON
Match the video impedance
1 2 3 4 5
6
ON(1)
O N
=
Descriptions
Setting
OFF(0)
O N
=
-9-