dvblogic TF-MFD3 매뉴얼 - 페이지 4

{카테고리_이름} dvblogic TF-MFD3에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dvblogic TF-MFD3 5 페이지. Tv-free video-in-motion interface for volkswagen mfd3/rns510, skoda columbus and seat trinax navigation systems

페이지 인쇄
dvblogic TF-MFD3 매뉴얼
Pin-assignment of the CAN-Box TV-500 (Molex 8pin)
Cable colour
Pin-No. Assignment
●
Yellow
Pin 4
●
Blue
Pin 3
●● Yellow/Black Pin 8
●● Blue/Black
Pin 7
●
Red
Pin 1
●
Black
Pin 5
●
Green
Pin 6
●
White
Pin 2

2. Installation

Switch off ignition and disconnect the vehicle's battery! If according to factory rules
disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle is
sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a
resistor lead.
Instruction for VW Golf 5, Touran with MFD3/RNS510:
1. Remove decorative plastic panels of the navigation
computer carefully, remove the 4 TORX screws and pull the
navigation computer out of the centre console with the
accordant tool kit (not included).
2. Disconnect Quadlock connector from the backside of the
navigation computer and connect it to harness TV-VW02. If
the original Quadlock connector carries 12pin inserts,
disconnect the inserts and connect them to harness TV-VW02.
Connect TV-VW02 to the navigation computer.
Version 29.01.2013
CAN-HIGH – connection to the head-unit
CAN-LOW – connection to the head-unit
CAN-HIGH – connection to the vehicle
CAN-LOW – connection to the vehicle
+12V permanent
Ground
Activation of the video-in-motion function
(+12V = TV-free activated)
Trigger output (+12V DC 500mA)
TF-MFD3