4qd HIB-DNO 사용 설명서 - 페이지 3

{카테고리_이름} 4qd HIB-DNO에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4qd HIB-DNO 3 페이지. Hall throttle interface board

DNO settings

The DNO gain adjustment will need to be turned fully clockwise to allow full speed

to be reached.

Calibration

The HIB-DNO should not require calibration when used with a 5V hall effect

throttle that draws around 10mA. If you wish to use a different throttle there is

a trimmer potentiometer that can be used to adjust the hall device current, this

can be accessed by cutting a small hole in the heat shrink tubing.

HIB-DNO V1.1 05/22

Page 3