Grease Guard G2 매뉴얼 - 페이지 2
{카테고리_이름} Grease Guard G2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Grease Guard G2 10 페이지.
The following tools are required for the installation
5/16" Hex key (provided with unit)
5/16" Hex head drive socket
Drill (recommended for 5/16" hex head screws
Drill (recommended for 5/16" hex head screws
Industrial type Scissors – (sharp)
Tape measure
Permanent Marker
Straight edge
WARNING!!!
Do not under any circumstances use a utility knife to cut the filters!!!
Utility knives will cut through to the roof surface causing serious damage
To the roof.
Tools Required
Of the G2 Grease Guard: