Great Lakes MINISTAR S 운영 매뉴얼 - 페이지 6

{카테고리_이름} Great Lakes MINISTAR S에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Great Lakes MINISTAR S 13 페이지.
Great Lakes MINISTAR S에 대해서도 마찬가지입니다: 문제 해결 및 제작 팁 (2 페이지)

페이지 인쇄

Maintenance

A regular maintenance schedule should be followed. Proper maintenance will assure better fabrication results. Refrain

from using water in the MiniSTAR S machine. Water may cause certain components to rust or corrode. When the machine

is not being used, engage the clamping frame to the chamber and position the chamber on the pellet cup. This prevents

lab dust from entering the pellet cup and chamber.

Pellets will become dirty with regular use. Clean pellets by

placing them in a strainer and rinsing with hot water. Spread

pellets on a towel and let air dry before placing them back in

the MiniSTAR S. Check pellets monthly. Discard and replace

pellets in the bottom third of the cup.

Air escape holes are present in the base of the pellet cup and

should be checked monthly to ensure that they remain open.

Use a .036 " diameter or smaller wire to open plugged holes.

Clean and inspect top and side of the Adjusting

every 4-6 months.

• Clean gasket with a soft cloth

• Check potential gasket cuts or irregularities

*Adjusting Ring is assembled from four components:

Chamber sealing ring

Aluminum ring

Side gasket

Spring-loaded adjusting pins

*Adjusting Ring should move freely in the chamber. If not,

after cleaning, apply a thin coat of Silicone Grease (016-021)

to inner wall of the chamber, 4 spring-loaded adjusting pins,

and outside edge of the adjusting ring (see white arrows).

Ring*