GREAT PLAINS Nutri-Pro NP1330AA 조정 매뉴얼 - 페이지 6

{카테고리_이름} GREAT PLAINS Nutri-Pro NP1330AA에 대한 조정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLAINS Nutri-Pro NP1330AA 6 페이지. Pull-type 3-section anhydrous shank
GREAT PLAINS Nutri-Pro NP1330AA에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (10 페이지)

페이지 인쇄

Rear Eye Bolt Adjustment: Side to side levelness at the rear

of the applicator is controlled by the eye bolts located on the

lift-assist cylinder bases. On pull-types the rear height is con-

trolled by the cylinders, slaved to the hydraulic depth stop

3.5"

valve. Check to see that both eye bolts are set to the same dis-

tance.

1) The factory setting is 3.5 inches from the end of the eye bolt

to the top face of the lug tube.

2) To adjust the eye bolt, loosen the hose guide nut and jam

nut.

3) Rotate the adjustment nut to until the eye bolt is at the

desired length.

48628

4) Check that the hose guide is on top and tighten the jam nut

along with the hose guide nut.

Pull-Type Wing Leveling: On pull-type applicators, wing lev-

elness is controlled by the gauge wheel lift cylinders and the

top eye bolt. If wings get out of level, re-phase the cylinders

across the applicator. If the wings are still not level, check that

the eye bolt length is still set at the factory setting.

1) The factory setting is 3.5 inches from the end of the eye bolt

to the top face of the gauge wheel lug tube.

2) To adjust the eye bolt, loosen the hose guide nut and jam

nut.

3) Rotate the adjustment nut to until the eye bolt is at the

desired length.

4) Check that the hose guide is on top and tighten the jam nut

along with the hose guide nut.

6 of 6

Document

#PAUS200C-0010A