GREAT PLAINS Nutri-Pro NP1330AA Руководство по регулировке - Страница 6
Просмотреть онлайн или скачать pdf Руководство по регулировке для Сельскохозяйственное оборудование GREAT PLAINS Nutri-Pro NP1330AA. GREAT PLAINS Nutri-Pro NP1330AA 6 страниц. Pull-type 3-section anhydrous shank
Также для GREAT PLAINS Nutri-Pro NP1330AA: Руководство по установке (10 страниц)
Печатать страницуRear Eye Bolt Adjustment: Side to side levelness at the rear
of the applicator is controlled by the eye bolts located on the
lift-assist cylinder bases. On pull-types the rear height is con-
trolled by the cylinders, slaved to the hydraulic depth stop
3.5"
valve. Check to see that both eye bolts are set to the same dis-
tance.
1) The factory setting is 3.5 inches from the end of the eye bolt
to the top face of the lug tube.
2) To adjust the eye bolt, loosen the hose guide nut and jam
nut.
3) Rotate the adjustment nut to until the eye bolt is at the
desired length.
48628
4) Check that the hose guide is on top and tighten the jam nut
along with the hose guide nut.
Pull-Type Wing Leveling: On pull-type applicators, wing lev-
elness is controlled by the gauge wheel lift cylinders and the
top eye bolt. If wings get out of level, re-phase the cylinders
across the applicator. If the wings are still not level, check that
the eye bolt length is still set at the factory setting.
1) The factory setting is 3.5 inches from the end of the eye bolt
to the top face of the gauge wheel lug tube.
2) To adjust the eye bolt, loosen the hose guide nut and jam
nut.
3) Rotate the adjustment nut to until the eye bolt is at the
desired length.
4) Check that the hose guide is on top and tighten the jam nut
along with the hose guide nut.
6 of 6
Document
#PAUS200C-0010A