GREAT PLAINS Nutri-Pro NP1330AA Aanpassingshandleiding - Pagina 6

Blader online of download pdf Aanpassingshandleiding voor {categorie_naam} GREAT PLAINS Nutri-Pro NP1330AA. GREAT PLAINS Nutri-Pro NP1330AA 6 pagina's. Pull-type 3-section anhydrous shank
Ook voor GREAT PLAINS Nutri-Pro NP1330AA: Handleiding voor installatie-instructies (10 pagina's)

Pagina afdrukken

Rear Eye Bolt Adjustment: Side to side levelness at the rear

of the applicator is controlled by the eye bolts located on the

lift-assist cylinder bases. On pull-types the rear height is con-

trolled by the cylinders, slaved to the hydraulic depth stop

3.5"

valve. Check to see that both eye bolts are set to the same dis-

tance.

1) The factory setting is 3.5 inches from the end of the eye bolt

to the top face of the lug tube.

2) To adjust the eye bolt, loosen the hose guide nut and jam

nut.

3) Rotate the adjustment nut to until the eye bolt is at the

desired length.

48628

4) Check that the hose guide is on top and tighten the jam nut

along with the hose guide nut.

Pull-Type Wing Leveling: On pull-type applicators, wing lev-

elness is controlled by the gauge wheel lift cylinders and the

top eye bolt. If wings get out of level, re-phase the cylinders

across the applicator. If the wings are still not level, check that

the eye bolt length is still set at the factory setting.

1) The factory setting is 3.5 inches from the end of the eye bolt

to the top face of the gauge wheel lug tube.

2) To adjust the eye bolt, loosen the hose guide nut and jam

nut.

3) Rotate the adjustment nut to until the eye bolt is at the

desired length.

4) Check that the hose guide is on top and tighten the jam nut

along with the hose guide nut.

6 of 6

Document

#PAUS200C-0010A