Aircraft Automation ECOTRIM 파일럿 매뉴얼 - 페이지 16

{카테고리_이름} Aircraft Automation ECOTRIM에 대한 파일럿 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aircraft Automation ECOTRIM 18 페이지. Trim system

Aircraft Automation

Pin 15: Fused (or breaker) power should be connected to this Red wire. The instrument

will run from 9 to 32 Volts DC and should be protected with a 3-amp fuse or breaker.

Connection to Servos:

Each servo (pitch and roll) is connected through a 3-pin standard Model Radio Control

connector:

- Pin 1 (black wire/black shrink tube): ground

- Pin 2 (White/Orange wire): 5-vdc servo supply

- Pin 3 (Blue/Orange wire): Pulse Width Modulation (PWM) servo command.

Connect each servo or extension so that the black wire is aligned with black wire/black

shrink tube. Reverse connection of these cables will prevent the servos from working

normally but will not produce any permanent damage.

NOTE: for trim tab installation please refer to the separate Trim Tab installation manual

or videos at:

https://aircraftautomation.com/support/

16 |

P a g e

ECOTRIM Trim System