GREAT PLANES COMBAT MUSTANG Combat P-51 ARF 사용 설명서 - 페이지 11

{카테고리_이름} GREAT PLANES COMBAT MUSTANG Combat P-51 ARF에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES COMBAT MUSTANG Combat P-51 ARF 20 페이지.

3. Slide the pushrod wire into the hole in the side of the

fuselage. Position a nylon control horn onto the elevator.

Mark the location of the screw holes. Then drill a 5/64"

[2mm] hole on the marks, drilling through the elevator. Install

the horn using two 2 x 19mm screws and the nylon plate.

Refer to this picture for the next three steps.

4. Insert the elevator servo into the servo tray. Using the

servo as your guide, drill a 1/16" [1.6mm] hole through the

servo tray for each of the mounting screws. Remove the

servo from the tray. Insert and then remove a servo

mounting screw (included with your servo) from each of the

holes you have drilled. Apply a couple of drops of thin CA

into the holes to harden the threads. When the CA has

cured, install the servo into the servo tray using the

hardware provided with your servo.

5. Install the screw-lock pushrod connector into the

last hole of the servo arm. Tighten it to the servo arm with a

washer and knurled nut. Slide the pushrod into the

connector. Center the servo arm and elevator. Tighten the

set screw against the pushrod wire. Cut off the excess

pushrod wire.

Install the Engine, Fuel Tank

& Throttle Servo

1. Assemble the fuel tank as shown. If you will be using

a fuel valve for filling the tank rather than filling the tank by

removing the line from the carburetor, install it in the fuel line

following the instructions included with the valve. Install the

tank into the fuselage, feeding the lines through the hole in

the firewall.