GREAT PLANES Gee Bee 사용 설명서 - 페이지 10

{카테고리_이름} GREAT PLANES Gee Bee에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Gee Bee 16 페이지. Model aircraft great planes gee bee

❏ ❏

6. Pull the elastic thread through the fuselage. Pass the

thread through the ﬂ ying wire retainer as shown.

❏ ❏

7. Follow the same procedure to install the aft ﬂ ying wire.

❏ ❏

8. Adjust the tension on the ﬂ ying wires so that there

is no slack in the elastic thread. But, they need to be able to

stretch if hit.

❏ ❏

9. Position the spreader bars so that the ﬂ ying wires are

straight. Apply a drop of CA on the joint between the spreader

bars and the ﬂ ying wires to hold the spreader bars in place.

❏

10. Return to step 1 and install the ﬂ ying wires through

the left wing.

❏

11. Pass the elastic thread through the two holes in the

belly pan and through the hole in one of the inside wheel pants.

❏

12. Glue the elastic thread to the wheel pant as before.

❏

13. Cut the elastic thread a little long at the other wheel

pant. Pass the thread through the wheel pant so that a slight

amount of tension is on the thread. Apply a drop of CA to the

thread. After the CA has hardened, trim the thread ﬂ ush with

the inside of the wheel pant.

BALANCE THE MODEL (C.G.)

CAUTION: Disconnect the motor battery and switch the

transmitter off.

❏

1. Slide the aluminum collet type prop adapter on the

motor shaft.