GREAT PLANES J-3 ElectriCub 사용 설명서 - 페이지 10

{카테고리_이름} GREAT PLANES J-3 ElectriCub에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES J-3 ElectriCub 20 페이지. Electric sport-scale arf

Install the Windscreen

1. Locate the trim line on the windscreen; it will be a small

recessed area showing where to cut for the proper shape. Cut

the windscreen a little at a time on this line with sharp scissors,

or canopy scissors. Test fit the windscreen often and trim it as

necessary. When you are happy with the fit, glue it in place

using canopy glue. Clear tape may be used as well, as

desired. Note: Do not use CA, it will fog the plastic.

1. Connect the wire pushrod to the second-from-the-

outer hole in a nylon control horn. You may have to enlarge

the hole in the horn using a sharp hobby knife.

2. Locate the pushrod exit tubes at the tail end of the

fuselage. They are located just forward of the horizontal

stab. If you cannot see them, feel for the slight indentation

through the covering or insert the pushrod into the pushrod

tubes inside the fuselage, and push the pushrods against

the covering. Cut the covering away from the pushrod exit

with a sharp hobby knife.

3. Slide the straight end of the pushrods into the fuselage

from the tail.

4. Position the control horn so that the pushrod mounting

holes are aligned with the hinge line. Mark the location of

the control horns' mounting holes on to the elevator and

rudder control surface. Drill two 1/16" [1.6mm] holes where

you marked them.

5. Using the 2 x 10mm machine screws provided, attach

the nylon control horn and tighten with the nylon back plate.

Be careful not to crush the wood when tightening.

1. Test fit the servo tray as shown in the photo, but do not

glue it in place. This will allow you to move the tray forward

or aft to assist with the balancing of the model.