GREAT PLANES J-3 ElectriCub 사용 설명서 - 페이지 8

{카테고리_이름} GREAT PLANES J-3 ElectriCub에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES J-3 ElectriCub 20 페이지. Electric sport-scale arf

3. Remove the covering from the landing gear slot in the

bottom of the fuse located just in front of the battery hatch.

4. Fit the landing gear into the fuse and test fit the

plywood triangle block. Lock the gear in place by gluing the

plywood triangle in the landing gear slot with CA.

Install the Tail Skid & Wing Braces

1. Place the fuselage upside-down on the workbench

and cut the covering away from the two holes for installing

the tail skid. Remove a small strip of covering from between

the two holes and securely glue the tail skid in place.

2. Locate and cut out the four holes to the front and rear of

the wing saddle for the dowel rods. Insert the wing dowels in

the holes and center. When centered, securely glue them in

place using a few drops of thin CA.

3. Temporarily install the battery cover. Drill a 1/16"

[1.6mm] hole approximately 1/8" [3mm] in front of the

battery compartment, closest to the landing gear. Attach the

battery cover latch to the fuse, using the supplied

2.5 x 8mm self-tapping screw. Do not overtighten; the latch

must be able to move, but not freely.

4. Carefully remove the covering from the battery cooling

holes on the battery cover with a sharp hobby knife.