GREAT PLANES J-3 ElectriCub 사용 설명서 - 페이지 9

{카테고리_이름} GREAT PLANES J-3 ElectriCub에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES J-3 ElectriCub 20 페이지. Electric sport-scale arf

Assemble the Tail

1. Center and align the LE of the horizontal stab with the

centerline of the fuse. Pin the front center of the stab to the

centerline of the fuse.

2. Locate the center stringer running the length of the fuse

on the top. This is the centerline of the fuse. Attach one end of

a piece of string to the centerline using a T-pin or piece of

masking tape, just behind the wing saddle, and extend the

string to the left outer edge of the stabilizer. Mark the string at

that location on a piece of tape. Move the end of the string to

the other side of the stab. Rotate the stab until both lengths are

the same. Pin the TE of the stab to the fuse.

3. Using a fine point felt-tip pen, mark the covering on the

bottom of the stab where it contacts the fuse.

4. Remove the stab. Cut the covering from the marked

area of the stab and from the gap on the front of the stab.

Note: Be careful not to cut into the balsa stab when

removing the covering.

5. Mount the wing to the fuse with two of the rubber

bands included with this kit. Pin the stab to the fuse; check

from behind the aircraft to make sure the stab is parallel with

the wing. Lift the stab off, and coat the stab where the

covering was removed and the fuselage with 30-min epoxy.

Reinstall the stab with the pin for guidance.

6. Center the fin on the stab and align it with the center of the

fuse. The front of the fin will slide into a notch in the front of the

horizontal stab. Mark the stab on both sides of the base of the

fin. Remove the covering from the marked area of the top of the

stab and the bottom of the fin. Note: Be careful not to cut into

the balsa stab when removing the covering.

7. Using 30-min epoxy, glue the fin to the stab, making

sure to keep it aligned with the centerline of the fuse and

perpendicular to the stab until the glue is fully cured.