GREAT PLANES YAK-55M Yakovlev 사용 설명서 - 페이지 8

{카테고리_이름} GREAT PLANES YAK-55M Yakovlev에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES YAK-55M Yakovlev 20 페이지. Arf plane

❏

2. Center the horizontal stabilizer, side-to-side, in the

slot in the fuselage. Also measure the distance from the tips

of the stab to the center of the fuselage. Adjust the position

of the stab until the distance is equal.

❏

3. Stand back and look at the stabilizer in relation to the

wing. The stabilizer should be parallel with the wing. If not,

lightly sand the stabilizer saddle until the stabilizer and wings

are aligned.

❏

4. Insert the elevator joiner wire in the notch at the back

of the stabilizer saddle. Use 30-minute epoxy to glue the

stabilizer in place, being careful that the stabilizer is properly

aligned. Tip: Place a piece of masking tape on the top and

bottom of the stabilizer, just outside the cut covering. Insert the

stabilizer in the fuse so that part of the bare wood is showing.

Apply 30-minute epoxy to the wood, top and bottom. Slide the

stabilizer through the fuse so that approximately 1/2" [12.7mm]

of bare wood is showing on the other side and apply epoxy

to the wood. Now align the stabilizer, remove the masking

tape and wipe off any excess epoxy from the stabilizer and

fuselage. Recheck that the stabilizer is still aligned.

You can now remove the wings and continue with the

assembly of the fuselage.

Install the Elevators

❏

1. Test fit the elevators to the stabilizer with the CA hinges.

If the hinges don't remain centered, stick a pin through the

middle of the hinge to hold it in position.

❏

2. Install three CA hinges into each elevator half. Install

the elevators onto the stabilizer with the elevator joiner