GREAT PLANES YAK-55M Yakovlev 사용 설명서 - 페이지 6

{카테고리_이름} GREAT PLANES YAK-55M Yakovlev에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES YAK-55M Yakovlev 20 페이지. Arf plane

페이지 인쇄

PREPARATIONS

❏

1. If you have not done so already, remove the major parts

of the kit from the box and inspect for damage. If any parts

are damaged or missing, contact Product Support at the

address or telephone number listed in the "Kit Inspection"

section on page 4.

❏

2. Remove the parts from the bags. Use a covering iron

with a covering sock on medium heat to tighten the covering if

necessary. Apply pressure over sheeted areas to thoroughly

bond the covering to the wood.

ASSEMBLE THE WINGS

Do the right wing first so your work matches the photos the

first time through.

❏ ❏

1. Install a 9" servo extension onto the servo lead. Secure

the extension to the lead with tape, a piece of shrink tube or

some other method to keep them from coming unplugged.

❏ ❏

2. Insert the servo lead in the aileron servo opening

and route the lead out the root of the wing. NOTE: The

Futaba S3150 servo is 2mm longer than the S3115 servo. If

the S3150 servo is installed, both ends of the aileron servo

opening will need to be trimmed approximately 1/32" [1mm].

❏ ❏

3. Install the servo into the servo opening. Drill through

the servo mounting holes with a 1/16" [1.6mm] drill bit.

Remove the servo from the servo opening. Install and then

remove a servo mounting screw into each of the holes you

have drilled. Apply a drop of thin CA into the holes to harden

the threads. Once the glue has cured install the servo into the

servo opening. Do not install the brass grommets or rubber

bushings in the servo. Secure the servo to the wing with the

servo mounting screws and #2 flat washers. Center the servo

and then install a servo arm as shown. The arm should be

pointing towards the wingtip, parallel with the aileron hinge line.

❏ ❏

4. Thread a nylon clevis, 16 turns, onto a 6" [152mm]

wire pushrod.

CORRECT

Hinge Line

❏ ❏

5. Attach the clevis in the outer hole of a nylon control

horn. Place the control horn in line with the outer hole in the

servo arm. When positioned properly the control horn will

INCORRECT

Hinge Line