GREAT PLANES YAK-55M Yakovlev 사용 설명서 - 페이지 7

{카테고리_이름} GREAT PLANES YAK-55M Yakovlev에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES YAK-55M Yakovlev 20 페이지. Arf plane

rest on a hardwood block in the aileron. Mark the location

of the mounting holes onto the aileron. Drill a 1/16" [3.2mm]

hole on the marks, approximately 3/8" [9.5mm] deep. Do not

drill completely through the top of the aileron.

❏ ❏

6. Thread two #2 x 3/8" [9.5mm] self-tapping screws

through the control horn, into the aileron control horn block.

Remove the two screws and harden the screw holes in the

aileron with thin CA. After the CA has cured, reinstall the

control horn.

❏ ❏

7. Slide a silicone clevis retainer over the clevis. With

the aileron servo and the aileron centered, mark the aileron

pushrod where it crosses the aileron servo arm. Make a 90°

bend at the mark. Cut the pushrod 3/8" [9.5mm] past the

bend. Attach the pushrod to the aileron servo arm with a

™

nylon Faslink

❏ ❏

8. Use thin CA to glue the two plastic wing alignment

pins in the root rib. The pins should protrude from the rib

approximately 1/4" [6.4mm].

❏

9. Repeat steps 1-8 for the left wing panel.

ASSEMBLE THE FUSELAGE

❏

1. Center the wing tube in the fuselage. Slide the wing

halves onto the wing tube and secure the wing halves to the

fuselage with the aluminum thumb screws.