AFG 7.1AT 빠른 조립 매뉴얼 - 페이지 4

{카테고리_이름} AFG 7.1AT에 대한 빠른 조립 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AFG 7.1AT 5 페이지.

페이지 인쇄

ASSEMBLY STEP 4

HARDWARE fOR STEP 4 :

BOLT (F)

12 mm

Qty: 4

HANDLEBARS

CONSOLE CABLES

CENTER BAR

ASSEMBLY STEP 5

HARDWARE fOR STEP 5 :

BOLT (I)

15 mm

Qty: 6

SPRING WASHER (G)

ARC WASHER (H)

6.2 mm

Qty: 4

ARC WASHERS (H)

SPRING WASHERS (G)

BOLTS (F)

FLAT WASHER (E)

SPRING WASHER (B)

8.2 mm

Qty: 6

CONSOLE

CONSOLE CABLES

HANDLEBARS

BOLTS (I)

SPRING WASHERS (B)

FLAT WASHERS (E)

Open hardware for step 4.

Connect the console cables, discard the

twist tie and slide the console cables into the

center bar.

Attach handlebars to center bar using 4

bolts (e), 4 spring washers (f) and 4 arc

washers (g).

NOTE: Do not tighten bolts until step 5 is complete.

Do not pinch wires while assembling the handlebars.

Attach console cables from handlebars

to console cables from console. Gently

tuck excess cable into console before sliding the

handlebars onto console.

Attach handlebars to console using 6

bolts (i), 6 spring washers (b) and 6 flat

washers (e).

Completely tighten all bolts from step 4.

NOTE: Do not pinch wires while attaching

the handlebars.

IMPORTANT

This treadmill has a pre-waxed belt and

should never be lubricated. Waxing

the belt can cause damage that is not

covered by the warranty.

YOU ARE FINISHED!