Celect DRF4 사용 설명서 - 페이지 4

{카테고리_이름} Celect DRF4에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Celect DRF4 8 페이지. Rf programmable thermostat for weekday/weekend setting

etc. The metal objects or electronic devices maybe

interfere with the RF communication, so maximum

distance will be shorter.

4. Do not mount onto metal wall boxes.

A. Installation, Mounting:

Caution:

Turn off DRF4 and the electrical devices (e.g. heater,

cooler) which will be connected before installation.

It is highly recommended that the installation procedure

is processed by trained personnel.

1. Installation Location:

The thermostat (Receiver and Transmitter) should be

mounted on an inner wall 1.5m above the floor in position

where it is readily affected by changes of the general

room temperature with freely circulating air. Prevent direct

exposure to sunlight; dripping or splashing area. Do not

place this unit at a location where air circulation is low, or

where it has great temperature changes (e.g. near door).

irrespective of the current setting temperature.

Control Off mode:

The LCD is fully turned off. The heater/ cooler is switched

off, irrespective of the current control temperature setting.

I. Jumper selection:

Delay / No Delay jumper:

No delay

Delay

Choose the Delay option if compressor heat is

connected.

12-hours / 24-hours mode jumper:

When the 12-hours option is selected, the time is

shown in 12-hours mode. Otherwise, the time is

shown in 24-hours mode.

Heater / Cooler jumper:

Select the heater option when a heater is connected to

Heater

Cooler

10sec

4mins