HIBLOW HP Series 매뉴얼 - 페이지 5

{카테고리_이름} HIBLOW HP Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIBLOW HP Series 9 페이지.
HIBLOW HP Series에 대해서도 마찬가지입니다: 매뉴얼 (5 페이지), 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (7 페이지)

페이지 인쇄

HP- 100 / 120

STEP

FITTING THE CHAMBER BLOCKS

Fit the actuating rod by aligning it with the groove

and tighten U-lock nut and flat washer by the nut

driver.

●Use new U-lock nut and washer, otherwise, U-lock nut

may work loose and cause malfunction.

STEP

Insert the actuating rod into the machine body. Be

sure to fit the positioning boss on the diaphragm

base into the concave part of the frame stay.

Secure the diaphragm mounting block on the

other side and tighten washers and U-lock nuts

with the nut driver.

Make sure that gap between the actuating rod

and the electromagnets is even.

STEP

Mount the casing block with screws (4 screws on

each side).

And insert L-tube into the nozzle of casing A.

Then, fix it with hose clip.

Complete the other casing block in the same way.

STEP

REPLACEMENT OF SAFETY PIN

Check that the broken pin is removed from unit.

●If the broken pin is left inside the unit, it can get caught

in between electromagnets and actuating rod, which

can cause breakdown.

REPLACING THE CHAMBER BLOCK