Automatic Technology Megacode Tricode 128 매뉴얼 - 페이지 8

{카테고리_이름} Automatic Technology Megacode Tricode 128에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Automatic Technology Megacode Tricode 128 20 페이지. Multi-frequency four channel receiver

페이지 인쇄

Automatic Technology Megacode Tricode 128 매뉴얼

4. Coding Transmitter

The MegaCode

receiver can store up to five hundred and eleven

(511) transmitters in its memory. Each transmitter can be allocated

an alpha-numeric ID label up to eleven (11) characters in length

and each button can be assigned to any channel. The settings for a

transmitter are represented in

store number, ID label or serial number and the functions assigned

to each of its four buttons. To toggle between ID/SN display, press

UP/DOWN with the cursor on the ID/SN indicator.

Brand Of Transmitters

The first memory location sets the type of transmitters which can be

stored into the memory of the receiver. It either can be Automatic

Technology TrioCode™128 or B&D Tri-Tran

example, if the first transmitter stored is TrioCode™128, then the

rest of the transmitters can only be the TrioCode™128 type and

mixing of TrioCode™128, Tri-Tran

of all stored transmitter codes from the receivers memory

will allow you to choose either TrioCode™128 or Tri-Tran

transmitters again.

4.1 Coding Transmitter Button

Navigating To Menu 1 "Code Transmitter"

a. Press NEXT to navigate to Menu 1

b. Press SET to enter the code set procedure.

Storing Transmitter Code

a. The controller will prompt to press one of the transmitter's

buttons.

b. Press and hold for approximately 2 seconds the transmitter

button you wish to use to operate the Door Opener (e.g. button

(Fig. 4.3)

c. Press the hold for approximately 2 seconds the same transmitter

button again as prompted by the display

4.2 Selecting Function Of The Button

The controller will now show the transmitter's record, with

a cursor on the field for the button being coded

Use OPEN/CLOSE to select the function for the button.

Available functions:

M_# (Mimic)

PR# (Pulse/Reset)

S_# (Set)

VAC (Vacation)

NOTE: Where # is the output Number 1,2,3,4.

Press SET to save the settings or EXIT to abort without saving

(Fig. 4.6).

4.3 Returning To Main Screen

The "Code Transmitter" menu will now be shown. Press EXIT to

return to the MAIN SCREEN and test the transmitter.

MegaCode

Receiver Installation Instructions

(Fig.

4.1). It shows the transmitter's

™ transmitters. For

™ is not possible. The deletion

(Fig. 4.2).

(Fig.

4.4).

(Fig.

P_# (Pulse)

T_# (Toggle)

R_# (Reset)

---

(OFF)

ID/SN display indicator

Store number

M_1 T_4 PR_3 S_1

Output 1 function

Output 3 function

Output 2 function

™

MENU 1

Code Transmitter

Press Tx'er

Button! LIST—›

4.5).

Press Tx'er

Again!

2 I

[ No Name ]

M_∆ --- --- ---

2 I

[ No Name ]

M_1 --- --- ---

I.D label/Serial number

NAME/SN

Fig 4.1

Output 4 function

Fig 4.2

PRESS

Fig 4.3

PRESS

Fig 4.4

Fig 4.5

PRESS

Fig 4.6

PRESS