GReddy Turbo Kit 설치 매뉴얼 - 페이지 12

{카테고리_이름} GReddy Turbo Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GReddy Turbo Kit 18 페이지. 96-98 nissan 240sx s14 (ka24de) td06-20g 8cm2
GReddy Turbo Kit에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (18 페이지)

페이지 인쇄

3-5 Intercooler Installation

1. Remove the auxiliary temp sensor on the

bumper reinforcement, and rotate it 180 , then

reinstall it back to the original mounting

location.

2. Install the intercooler mounting bracket to the

bumper reinforcement mounting bolt. Then

install the intercooler to the bracket.

*Adjust the bracket to mounting intercooler

parallel.

3. Remove the plastic part between the lower

radiator hose and bracket. Bend the bracket up

and secure it with zip ties as shown.

4. Install the compression pipe C-2 and C-3

between the C-1 to the intercooler with

provided hose and hose band.

Secure C-2 bracket to the speed sensor

harness bracket (RH).

(Parts Used #9, 10, 33, 36, 40, 41)

5. Install the compression pipe C-4, C-5, and C-6

between the intercooler and throttle using the

provided hoses and hose bands. Connect the

Jet Air Fuel Mixing sir hose to the fitting on the

back of C-6 pipe. This hose has a large

amount of suction when idling and is the top

hose that routes behind the alternator. It is

important to connect this hose properly to this

location.

(Parts Used #4, 5, 64)