HID Aero X1100 설치 매뉴얼 - 페이지 6
{카테고리_이름} HID Aero X1100에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HID Aero X1100 8 페이지. Intelligent controller
페이지 인쇄
Powering
Trusted Identities
Status LEDs
LED
BATT FAIL
AC FAIL
TAMPER
IN 1
IN 2
IN 3
IN 4
ONLINE
ON for approximately 15 seconds
HOST COMM
IO INTERNAL
IO MODULE PORT 1
IO MODULE PORT 2
READER 1
READER 2
RELAY 1
RELAY 2
RELAY 3
RELAY 4
ETHERNET
*If this input is defined, every three seconds the LED is pulsed to its opposite state for 0.1 seconds, otherwise,
the LED is OFF.
6
POWER ON SELF-TEST
On then OFF
On then OFF
On then OFF
On then OFF
On then OFF
On then OFF
On then OFF
ON for approximately 1 second
ON for approximately 1 second
ON for approximately 1 second
ON for approximately 1 second
ON for approximately 1 second
ON for approximately 1 second
OFF
OFF
OFF
OFF
OFF
HID Aero™ X1100 Installation Guide
NORMAL OPERATION
OFF = Inactive, ON = Active, Flash = Fault.*
OFF = Inactive, ON = Active, Flash = Fault.*
OFF = Inactive, ON = Active, Flash = Fault.*
OFF = Inactive, ON = Active, Flash = Fault.*
OFF = Inactive, ON = Active, Flash = Fault.*
OFF = Inactive, ON = Active, Flash = Fault.*
OFF = Inactive, ON = Active, Flash = Fault.*
Off-Line / On-Line and battery status.
On-Line = A long flash ON and a short flash OFF.
Off-Line = A short flash ON and a long flash OFF.
Double flash if battery is low.
Host communication activity (Ethernet).
Internal IO module communication activity.
External IO module activity (Port 1).
External IO module activity (Port 2).
OSDP Mode = Flashes when transmitting data.
Wiegand or C&D Mode = Flashes when data is received,
either input.
OSDP Mode = Flashes when transmitting data.
Wiegand or C&D Mode = Flashes when data is received,
either input.
ON = Energized.
ON = Energized.
ON = Energized.
ON = Energized.
ETHERNET LED on Cover: Flashing = Ethernet activity
ETHERNET JACK:
Green/Left ON = good link
Yellow/Right is ON = 100 Mb/s and OFF = 10 Mb/s
PLT-04233, Rev. A.3