ADEMCO LYNX 시스템 매뉴얼 - 페이지 10

{카테고리_이름} ADEMCO LYNX에 대한 시스템 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADEMCO LYNX 14 페이지.
ADEMCO LYNX에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 빠른 시작 매뉴얼 (8 페이지)

Ademco Lynx System Manual

system will announce "END MESSAGE" and "REC MESSAGE" will not be displayed. If the

message center is full all old messages must be deleted before new messages can be recorded.

See Deleting Messages section.

Message Playback

The lighted word MESSAGE indicates that a new message is in memory. After playing the message, the

MESSAGE display turns off.

To play a message, press [FUNCTION] + [PLAY].

All recorded messages will be announced sequentially. A short beep will sound between messages.

To skip a message, press [*].

NOTE: If a wireless keypad has been installed and is programmed for quick arming, it cannot

be used to activate message playback or adjust the volume. In this case, you must use the

master keypad to perform these functions.

Deleting Messages

To delete all messages:

1. Press [FUNCTION] + [PLAY].

2. While the messages are being announced, press [FUNCTION] + [DELETE].

3. A double beep will sound confirming that the messages have been deleted.

Adjusting the Volume

The volume level of message playback, system announcements, and status beeps can be changed. You

can also mute system announcements if desired.

To adjust message playback/system announcement volume:

1. Press [FUNCTION] + [VOLUME] + [3] to increase or [6] to decrease volume level.

2. Repeat the key sequence until the desired volume level is achieved.

To mute system announcements:

1. Press [FUNCTION] + [VOLUME] + [OFF].

2. The volume level will be restored to the level that was selected prior to muting the sound.

Paging Features

Automatic Paging

http://alpha.adt.com/help/261[11/14/2018 8:02:22 PM]