Gainlab Audio GL-TC1 매뉴얼 - 페이지 9

{카테고리_이름} Gainlab Audio GL-TC1에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gainlab Audio GL-TC1 16 페이지. Dictator stereo vari-m compressor

Due to the nature of the equipment, the higher the gain reduction value, the

higher the compression ratio. To adjust the threshold level, turn the knob

labeled THRESHOLD clockwise to set the lower threshold level, or turn the knob

counterclockwise to set the higher threshold level.

CHANNEL LINK/UNLINK

be advantageous to eliminate the coexistence of the two channels. In this case, it

is possible to separate the auxiliary circuits of the device. To separate the

auxiliary circuits, use the switch once and check on the lower indicator lights

that the compressor is in the desired operating condition. Use the switch

again to return to linked mode.

allow a signal to go to the auxiliary circuit.

DICTATOR STEREO VARI-μ COMPRESSOR

The Dictator is set to two-channel mode by

default. In such cases, the aim is for the right

and left channels to run together as much as

possible. However, in certain situations, it may

Depending on the program signal, it is often necessary for

the dynamics controller not to react to deep frequency

components. In such cases, it is advisable to ﬁlter out

these low-frequency components from the auxiliary

circuit signal controlling the compressor with a high-pass

ﬁlter that does not allow a signal to the control circuit

below a set cut-oﬀ frequency.

To set the ﬁlter, turn the switch labeled SIDECHAIN

FILTER so that the rotary knob points towards the cut-

oﬀ frequency value below which you no longer want to

! 8