Hidro-Water NEREO 사용자 및 설치 관리자 매뉴얼 - 페이지 4

{카테고리_이름} Hidro-Water NEREO에 대한 사용자 및 설치 관리자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hidro-Water NEREO 13 페이지.

페이지 인쇄

4.- INSTALLATION

The system can be installed anywhere in the residence where there is a water input, a drain

for wastewater, a 220 – 240 V (only NEREO osmosis system with pump) socket within a metre and

sufficient space to be located. The most common place is under the kitchen sink. The installation

should be carried out by qualified personnel.

4.1.- Faucet installation (Figure-8)

a. Choose the location on the counter where you

want to install the faucet.

b. Use a drill with a 12mm bit to make a necessary

sized hole to put the faucet.

c. Fit the tap in the hole as indicated in the

image using a spanner (our reference: OI-

0207-128 not supplied with system) to adjust

it tightening the nut.

4.2.- Feed Adapter installation (Figure-13 & Figure-14)

The water supply input consists of two parts; a brass ball valve (Figure-14) and an adaptor

(Figure-13). The brass ball valve must be screwed to the adaptor using enough Teflon on its thread,

as shown in the image below.

a. Turn off the water supply at the point where you are installing the osmosis system.

b. The water supply input is designed to be used with hoses with a ⅜" connection. Insert the

water feed adapter with the brass ball valve between the cold water supply and the hose.

(Never install a hot water connection as the osmosis system will be damaged). Make sure that

the brass ball valve is closed.

Adapter

Connect to

water supply

Place Teflon

MA-EN-OSMOSIS NEREO-RO-0206-XX-PSM-21-V01.0

Connect 3/8 " Hose

Brass Ball Valve

Connect to the

Osmosis System

with 1/4 " Tube

4.3.- Drain clamp installation (Figure-12)

a. The drain clamp is designed to adjust the sealing

drainpipe to 1 ½".

b. The drain clamp should always be installed above the

U-bend (before it) and in the case of a horizontal drainpipe,

install it above (at the top). Do not install it near to the waste

outlet as it could clog the drainpipe.

c. Drill a 6mm hole in the drainpipe.

d. Align the clamp hole with the hole in the drainpipe and

carefully tighten the screws on the clamp until it is fixed into

place. Do not over tighten.

4.4.- Cartridge installation

a. The sediment (Figure-3), Carbon GAC (Figure-4) and Carbon CTO (Figure-5) cartridges be

taken out of the packaging and fitted in order as shown in the picture below to ensure a good

operation of the osmosis system.

NEREO

b. Screw in the housing filter carefully ensuring that the cartridges are centred so that they fit

correctly in the housing filter's adapter and cap.

c. Finish tightening the housing filters with the help of the wrench supplied with the

system (Figure-9).

MA-EN-OSMOSIS NEREO-RO-0206-XX-PSM-21-V01.0

NEREO WITH PUMP