Celestron CPC 925 사용자 설명서 - 페이지 2

{카테고리_이름} Celestron CPC 925에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Celestron CPC 925 14 페이지. Nexstar hand control
Celestron CPC 925에 대해서도 마찬가지입니다: 통신 프로토콜 매뉴얼 (8 페이지)

페이지 인쇄

Lift (two-person lift is strongly recommended) the

telescope from its storage box and place the telescope

base on the tripod top. Maintain a very firm grip on the

telescope. The tripod positioning pin needs to slip into a

hole in the bottom of the telescope base. You should

feel the telescope "clunk" down about 1cm when

properly centered on the pin. Maintain a firm hold on

the telescope side handle (the telescope is still at risk of

falling to the ground). Slowly rotate the telescope base

on the tripod top until you feel another "clunk" as the

telescope base matches the location of the three

mounting bolts that are on the under-side of the tripod head. Screw the three bolts into the

telescope base. The telescope is now attached to the tripod and no longer at risk of falling.

Attaching components to the telescope

Attach the hand controller and 12v

battery power cable.

On the left-side "shoulder" of the

telescope there is a large three-spoked

circular knob moulded into the telescope

fork arm. This is the declination

(up/down movement) knob. It

locks/unlocks the free movement of the

optical tube in the up/down range of

motion. Unscrew the knob and tilt the

optical tube to aim the from corrector plate

lens toward the sky. Retighten the knob.

In the center of the telescope base is a similar

knob (right ascension locking knob) that allows

the telescope to be rotated. If you wish, you

can unscrew this knob and turn the telescope

to face a different direction – and then

retighten the knob.

(Once you have completed the star alignment

procedure (explained below), do not unscrew

either of these knobs to move the telescope to

point in a different direction. If you do so, you

will mess up the star alignment and the

telescope will no longer be able to find the

objects you ask it to point to.)

Attach the finderscope, visual back and star diagonal

The finderscope is held in a quick-release bracket. Slide this bracket onto the finderscope mounting

bracket on the top of the telescope. Tighten the two bracket attachment screws.