Dynamic Projection Mirror Head MH17 빠른 설치 매뉴얼 - 페이지 4

{카테고리_이름} Dynamic Projection Mirror Head MH17에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynamic Projection Mirror Head MH17 8 페이지.

Mirror Head Quick Installation Guide
For the full manual please visit http://dynamicprojection.com/mirror-head-assembly
Mounting of the projector
For further help on assembly please watch our assembly videos: http://www.dynamicprojection.com/mirror-head-assembly/
5
2
3
4
8
Copyright © 2014 - 2017 Dynamic Projection Institute GmbH. All rights reserved. http://www.dynamicprojection.com
Weights and dimensions shown are approximate. Specifications and appearance are subject to change without notice.
1
6
7 .
Mount the base-plate to the projector and projector
frame. If the projector is already mounted to the frame
you have to remove the specific screws. WARNING:
Secure the projector at any time so it cannot fall out or
down. Use a second person to help.
8.
Lock-in the Mirror Head into the base-plate and secure
the two screws at the front and the two screws at the
bottom. NOTE: This step of the installation can be reversed.
9.
Connect the RS232 and AC power-cord to the projector
and control unit.
4
B
1.
Prepare the setscrew on the hex key
and put one drop of Loctite
screw-lock onto it.
2.
Turn the setscrew into the drive arm
by two turs.
3.
Slip over the end-stop (brass part)
over the pan drive shaft.
4.
Take the whole drive arm end slip it
over the pan drive shaft until it
reaches the end-stop.
5.
Secure the setscrew with the hex key.
6.
Connect the motor signal cable and
mount the glue strip on the motor.
7
QIG - Version 2.1