Dynavision D2 마운팅 매뉴얼 - 페이지 2

{카테고리_이름} Dynavision D2에 대한 마운팅 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynavision D2 3 페이지.

1. Unpack the D2 stand from skid, wheel to desired

mounting location. Desired area shall have a level

floor and close to an AC source. Set leveling casters

to level and stabilize rack (wheels off the floor).

2. Assemble the D2 according to the instructions

provided. Place the D2 close to the rack, laying

down as shown.

Units shall be placed where there is available access to an electrical outlet.

Refer to the Dynavision D2 assembly instructions for assembly and operation details

3. Open both rear panels with the keys supplied.

Connect the rack to an AC source. Raise the

rack to its maximum height.

4. Lift the D2 upright and place the D2 onto the

stand as shown. Holding on to the D2, connect

the the D2 to an AC source. Raise the unit to

expose the first mounting panel – next page.

To accomplish this step safely, you must employ 2 people to do the job.

An AC source is required in order to perform these instructions (units plugged in).

Refer to the Dynavision D2 assembly instructions for assembly and operation details