HighPoint RocketU 1388D 빠른 설치 매뉴얼 - 페이지 10

{카테고리_이름} HighPoint RocketU 1388D에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HighPoint RocketU 1388D 12 페이지. Pcie 3.0 to 8-port usb-c 3.2 10gb/s hba

Verifying Installation (Linux)

Open terminal and enter the following command:

lspci

If the driver is installed properly, four "ASM2142 USB 3.1 Host

Controller" entry should be displayed.

Note: USB3.1 has been renamed to USB3.2, but the system display

has not been updated to USB3.2, the current display is still USB3.1

1. Power on the system.

2. Connect the USB device to the HighPoint RocketU HBA with a USB

cable.

3. For hard drives or enclosures, allow the device to spin up for a few

moments. Once the devices are ready, they will be recognized by the

operating system and can be accessed as needed.