Dynex DX-DRTVM102 사용자 설명서 - 페이지 12

{카테고리_이름} Dynex DX-DRTVM102에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynex DX-DRTVM102 16 페이지. Support de montage mural de taille moyenne ultra-mince avec inclinaison de - 5° optionnelle
Dynex DX-DRTVM102에 대해서도 마찬가지입니다: (영어) 수동 조립 지침 (16 페이지), (프랑스어) 지침 드 몽타주 매뉴얼 (16 페이지)

페이지 인쇄

Step 6:

Mount the wall plate

Note: Any material covering the wall (such as sheetrock) must not exceed 5/8" (16 mm).

Option 1: Mounting on a wood-stud wall

Locate the studs. Verify the center of the stud with an edge-to-edge stud finder.

At the wall height you determined in the previous step, align the wall plate (01) against the wall and make sure

that it is level. Use a pencil to mark the screw hole locations, then remove the wall plate.

Drill pilot holes to a depth of 3" (75 mm) using a 7/32" (5.5 mm) diameter drill bit.

Align the wall plate with the pilot holes, then place the washers (05) over the holes in the wall plate. Insert the lag

bolts (04) through the washers, then tighten the lag bolts only until the washers are pulled firmly against the wall

plate.

Caution: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (04).

You'll need:

05 (2)

04 (2)

Stud

Pencil

finder

Need help? Call 800-305-2204

Level

Drill

DX-DRTVM102

< 5/8"

(16 mm)

3" (75 mm)

7/32" (5.5 mm)

Socket wrench with

wood drill

1/2" (13 mm) socket

or adjustable wrench