Dynex DX-DRTVM102 Podręcznik użytkownika - Strona 12

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Uchwyt TV Dynex DX-DRTVM102. Dynex DX-DRTVM102 16 stron. Support de montage mural de taille moyenne ultra-mince avec inclinaison de - 5° optionnelle
Również dla Dynex DX-DRTVM102: (Angielski) Instrukcja montażu (16 strony), (Francuski) Instrukcja montażu (16 strony)

Drukuj stronę

Step 6:

Mount the wall plate

Note: Any material covering the wall (such as sheetrock) must not exceed 5/8" (16 mm).

Option 1: Mounting on a wood-stud wall

Locate the studs. Verify the center of the stud with an edge-to-edge stud finder.

At the wall height you determined in the previous step, align the wall plate (01) against the wall and make sure

that it is level. Use a pencil to mark the screw hole locations, then remove the wall plate.

Drill pilot holes to a depth of 3" (75 mm) using a 7/32" (5.5 mm) diameter drill bit.

Align the wall plate with the pilot holes, then place the washers (05) over the holes in the wall plate. Insert the lag

bolts (04) through the washers, then tighten the lag bolts only until the washers are pulled firmly against the wall

plate.

Caution: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (04).

You'll need:

05 (2)

04 (2)

Stud

Pencil

finder

Need help? Call 800-305-2204

Level

Drill

DX-DRTVM102

< 5/8"

(16 mm)

3" (75 mm)

7/32" (5.5 mm)

Socket wrench with

wood drill

1/2" (13 mm) socket

or adjustable wrench