Dynex DX-DRTVM102 Kullanıcı Kılavuzu - Sayfa 12
TV Montajı Dynex DX-DRTVM102 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dynex DX-DRTVM102 16 sayfaları. Support de montage mural de taille moyenne ultra-mince avec inclinaison de - 5° optionnelle
Ayrıca Dynex DX-DRTVM102 için: (İngilizce) Manuel Montaj Talimatları (16 sayfalar), (Fransızca) Instructions De Montage Manual (16 sayfalar)
12
Step 6:
Mount the wall plate
Note: Any material covering the wall (such as sheetrock) must not exceed 5/8" (16 mm).
Option 1: Mounting on a wood-stud wall
Locate the studs. Verify the center of the stud with an edge-to-edge stud finder.
At the wall height you determined in the previous step, align the wall plate (01) against the wall and make sure
that it is level. Use a pencil to mark the screw hole locations, then remove the wall plate.
Drill pilot holes to a depth of 3" (75 mm) using a 7/32" (5.5 mm) diameter drill bit.
Align the wall plate with the pilot holes, then place the washers (05) over the holes in the wall plate. Insert the lag
bolts (04) through the washers, then tighten the lag bolts only until the washers are pulled firmly against the wall
plate.
Caution: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (04).
You'll need:
05 (2)
04 (2)
01
04
05
Stud
Pencil
finder
Need help? Call 800-305-2204
01
Level
Drill
DX-DRTVM102
< 5/8"
(16 mm)
3" (75 mm)
7/32" (5.5 mm)
Socket wrench with
wood drill
1/2" (13 mm) socket
or adjustable wrench