Galvin Specialised Ezy-Drink CP-BS TD15EB 제품 설치 매뉴얼 - 페이지 2

{카테고리_이름} Galvin Specialised Ezy-Drink CP-BS TD15EB에 대한 제품 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Specialised Ezy-Drink CP-BS TD15EB 4 페이지. Remote electronic drinking bubbler tap - battery

페이지 인쇄

TOOLS REQUIRED

−

Power drill

−

Spanner or adjustable crescent

−

Screw driver

PRE-INSTALLATION -

−

If the mounting holes do not already exist, mark out and drill

the holes in the bench/trough, as shown in rough-in

dimensions.

Note: Supplied flexi hose length is 225mm long.

Note: Before installation, all lines must be flushed.

We recommend that a line strainer be installed prior to drinking

taps to eliminate any foreign material.

INSTALLATION

IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions

and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical

supply conditions must also comply to the applicable national and/or state standards. Failing to comply with these

provisions shall void the product warranty and may affect the performance of the product.

1. Disassemble piezo button and outlet

− Remove backnuts and washers as

shown.

MOUNTING DETAILS

Rough-In Dimensions

2. Fit mouthguard outlet

−

Fit the body and mouthguard outlet into the trough.

−

Ensure the sealing rubber washers are placed

underneath the mouthguard outlet body.

−

Secure underneath with the supplied cup washer and

back nut.

Version 1, 16

June, Page 2 of 4